Bryce 9K-L Especificaciones descargar pdf (Pagina 26)

Operating the Printer

The Wire Form Assembly helps the printer feed the media.

Use the following suggestions as a guide for setting the height

of the Wire Form Assembly. When the media is:

Wire Form

Height

Adjustment

• Heavy media- set low

• Light media - set high.

• Rigid media - set low

To adjust the Wire Form Assembly:

1. Loosen the Carriage Knob on the Feed Carriage

Assembly.

Adjust Feed Ramp and Wire Form Assembly

2. Move the Wire Form Assembly accordingly.

3. Tighten the Carriage Knob to secure the Wire Form

Assembly in place.

Adjust the Feed Ramp Assembly beneath the rear edge of the

media by:

Feed Ramp

Adjustment

1. Loosen the Knob on the Feed Ramp Assembly.

2. Lower Feed Ramp beneath the back edge of the media.

Place ramp where the media is halfway up the angled

front edge.

3. Tighten Knob to lock Feed Ramp into position.

Revision A 9K-L USERS MANUAL Section 4 -

P/N 90-00860-001

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 150 151

Sin comentarios

Bryce 9K-L Especificaciones Pagina 26